Motor Control | DC Motor

Part-No./Function Interface FlexRayTM Standard Recommended IMAX Efficiency Output Range Transducer frequency Driver output Memory Detection Sensitivity Bandwidth VBAT VOUT VSUPPLY Protection ISUPPLY IPEAK IMAX DC P(Motor) peak P(Motor)max VDD VER Iq RDSON ESD (kV) Bitrate Cranking Support High-Side Driven Low-Side Driven Bi-Stabil Included µC Feed-Back Inputs Package Status Comment
E523.30 (*SoC / *Plug & Play)
1.6A DC Motor 2x Full Bridge Controller (LIN / PWM Interface)
  • LIN 2.x (1.3) or
  • SAE-J2602 or
  • PWM bidirectional
  • LIN auto-addressing
    (slave mode position
    detection)
  • LIN Flash update for
    EoL and Service
  • JTAG
    7V to 20V (5.5V to 42V) - 1.6A (1 Motor Mode) ≈25W (per Motor)

    ≈25W
    (per Motor)

    225mΩ (HS) 275mΩ (LS)

    QFN32L6

    • Drives 1 or 2 DC motors
    • 8bit CPU, 8k FLASH, 64Byte E2PROM
    • Current chopper motor control
    • Supply and read-out of up to 3, potentiometers or sensors
    • GPIO-pins
    • TJunc peak = +170°C
      (contact supplier for higher temperatures)
    • (*Plug & Play) - Application software on request
      E523.60/61 (*SoC / *Plug & Play)
      0.38A DC Motor 2x Full Bridge Controller (LIN / PWM Interface)
      • LIN 2.x (1.3) or
      • SAE-J2602 or
      • PWM bidirectional
      • LIN auto-addressing
        (slave mode position
        detection)
      • LIN Flash update
      • JTAG

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

         

        7V to 18V (5.5V to 42V) - 380mA (1 Motor Mode)

        ≈7W
        (1 Motor Mode)

         

        1Ω (HS) 1Ω (LS)

         

        QFN32L6

         

         

         

        • Drives 1 or 2 DC motors
        • 8bit CPU, 8k FLASH (E523.60), 8k ROM (E523.61), 64Byte E2PROM
        • Current chopper motor control
        • Supply and read-out of up to 3, potentiometers or sensors
        • GPIO-pins
        • TJunc peak = +170°C
          (contact supplier for higher temperatures)
        • (*Plug & Play) - Application software on request